Written by
Daniel Reeves Appliance Repair Content SpecialistPublished October 20, 2026
Whirlpool®
Code overviewat a glance.
The facts for this Whirlpool error, a plain-language snapshot, and what to confirm against your model number.
F4E4
Error codeF4E4
ApplianceDryer
Content status
Verified
Quick answer
F4E4 explained for Whirlpool dryers: the home power supply, breaker and cord checks, and the laundry tower entry.
Model note: Whirlpool reuses codes across series and model years, so F4E4 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
Whirlpool®
What this codemay mean.
A plain-language reading of the code — always confirm against your model’s documentation.
Mean
F4E4 is a Low or No Line Voltage code; the home power supply may be keeping the dryer's heater from turning on.
If a Whirlpool dryer runs but does not heat and shows F4E4, the manual points at the household power. Low or No Line Voltage means something in the home supply may be stopping the heater from turning on.
What the manual says to check
Begin with the home breakers. An electric dryer is on a separate 30-amp circuit fused on both sides of the line, which means two breakers; one circuit operates the motor that turns the drum, the other operates the heating element. If either is tripped, the dryer may not heat, so verify both are on. Where the commercial-grade residential guidance applies, it adds that the dryer uses two household fuses or breakers, and a blown fuse should be replaced.
Then look at the cord. A proper installation matters, and the 240-volt supply an electric dryer needs should be confirmed with a qualified electrician. Before checking terminal screws, unplug the dryer, and keep the screws tight at the dryer end.
Restart
Touch any pad to clear the code.
Choose a Timed Dry heated cycle.
If the message persists, consult a qualified electrician.
Stacked laundry towers
These list a main heater potential cause instead. The power-off time is one minute for the dryer section and 5 minutes for the washer section, and a returning code means scheduling service.
Whirlpool dryer service in the Miami, New York, Houston, Los Angeles and San Diego metro areas
Dryers in the Miami, New York, Houston, Los Angeles and San Diego metro areas get support through (844) 968-2053. Mention F4E4, the model number and which power checks you made.
Stop immediately if you notice smoke, sparks, a burning smell, gas odor, or water near electrical parts.
Safe
Important
Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Whirlpool®
Seeing this codeon your appliance?
Book an Whirlpool appliance service visit for a clear estimate and approval before any repair.
Book
Experienced technicians, clear diagnostics, and workmanship coverage on completed repairs.
